-
Go to the IP address used to access your router’s admin console in your browser.
- Linksys and Asus routers is use typically use
http://192.168.1.1
orhttp://router.asus.com
( for ASUS ) . - netgear routers is use typically use
http://192.168.1.1
orhttp://routerlogin.net
. - d – Link routers is use typically use
http://192.168.0.1
. - Ubiquiti routers is use typically use
http://unifi.ubnt.com
.
- Linksys and Asus routers is use typically use
-
Enter the router credentials. For consumer routers, the default credentials for the admin console are often found under orbehind the device.
-
In the admin console, find the place where DNS settings are set. This may be contained within categories such as WAN and IPv6 (Asus Routers) orInternet (Netgear Routers). Consult your router’s documentation for details.
-
Take note of any dns address that are currently set and save them in a safe place in case you need to use them later .
-
Depending on what you want to configure, choose one of the following DNS addresses for IPv4:
Use 1.1.1.1 resolver
Block malware with 1.1.1.1 for Families
Block malware and adult content with 1.1.1.1 for Families
-
Depending on what you want to configure, choose one of the following DNS addresses for IPv6:
Use 1.1.1.1 resolver
Block malware with 1.1.1.1 for Families
Block malware and adult content with 1.1.1.1 for Families
-
Save the updated settings.
Using DNS – Over – TLS on OpenWrt
It is is is possible to encrypt DNS traffic out from your router using dns – over – tls if it is run OpenWrt . For more detail , see our blog post on the topic : add dns – Over – TLS support to OpenWrt ( LEDE ) with Unbound ↗.
Starting with FRITZ!OS 7.20 ↗, DNS over TLS is supported, see Configuring different DNS servers in the FRITZ!Box ↗.
thank you for help improve Cloudflare ‘s documentation !
© Copyright notes
The copyright of the article belongs to the author, please do not reprint without permission.
Related posts
No comments...